The DFW Handyman®Honest Craftsmanship.

Kitchen, bath and floors

Which small bathroom repairs can a handyman handle?

Where the line sits in a bathroom: accessories, a loose vanity, caulk and trim are handyman work, while faucets and toilets are licensed plumbing in Texas.

Your local expert

Hands-on since 1999 · About Daniel

The vanity back in service

The vanity back in service. From bathroom vanity repaired and reset, one of Daniel’s projects.

Short answerIt depends on whether the repair touches the water. Towel bars and accessories, a vanity cabinet that has worked loose, cabinet hardware, a shower door handle, caulk and grout, and the drywall or trim after a leak are handyman work. A running toilet, a loose toilet, a new faucet or showerhead, a sink pop-up drain and the supply lines under a sink are plumbing, and Texas licenses plumbing as a trade, including replacing fixtures and toilet parts. When you ask for one of those, ask who will do the plumbing part and whether they are licensed. We’ll tell you how we handle it on your job.

Key takeaways

  • Towel bars, accessories, a loose vanity cabinet, hardware, caulk and grout are handyman work.
  • Toilets and toilet parts, faucets, showerheads, pop-up drains and supply lines are plumbing, which Texas licenses, even when the new part goes on the existing lines.
  • A running toilet is almost always a flapper, fill valve or chain inside the tank.
  • A toilet that rocks needs attention soon: the seal underneath may already be leaking onto the floor.
  • Towel bars and accessories on tile need the right drill bit and anchoring, not just a screw in the grout.
  • List every small bathroom item together and mark the ones that touch the water, so you know who does each part.
In this guide
  1. The line: does the repair touch the water?
  2. Toilets: running, rocking or being replaced
  3. Showers, sinks and shower doors
  4. Towel bars, accessories and hardware
  5. A loose vanity, or a damaged vanity backsplash
  6. A leak you can’t see: call a plumber first
  7. Put the small things on one list

The line: does the repair touch the water?

Texas licenses plumbing as a trade, and the state’s definition is broad: it covers installing, repairing and maintaining fixtures as well as the pipes that serve them. That includes replacing a faucet, a toilet or the parts inside its tank, a showerhead, a pop-up drain or a supply line, even when the new part goes onto the lines you already have. Some of these repairs need no city plumbing permit, but whether a permit is needed is a separate question from who may do the work. If you own the home and live in it, Texas lets you do some plumbing on it yourself, though city rules and permits can still apply; that does not extend to someone you hire.

Everything around the water is a different matter. Towel bars, grab bars and accessories, a loose vanity cabinet, cabinet hardware, a shower door handle, caulk, grout and tile, and the drywall, trim or floor after a leak is fixed are handyman work. When you ask for a repair on the plumbing side, ask who will do the plumbing part and whether they are licensed. We’ll tell you how we handle it on your job. What should a handyman refer to a licensed electrician or plumber? lays out the full list.

Toilets: running, rocking or being replaced

  • A toilet that keeps running almost always has its cause inside the tank: a worn flapper that lets water leak into the bowl, a fill valve that won’t shut off, a float set too high, or a chain that catches. The parts are standard and inexpensive, but replacing them is plumbing repair in Texas, so ask who will do it and whether they are licensed.
  • A loose toilet base is worth dealing with soon. Sometimes the bolts at the base have simply loosened; overtightening them cracks porcelain. If the toilet has rocked for a while, the wax seal underneath has likely failed, and water may be reaching the floor. Resetting the toilet on a new seal, and any repair to the flange it bolts to, is plumbing. A soft floor under it is a carpentry repair, done once the plumbing side is sorted, so the toilet goes back down on something solid.
  • Replacing a toilet in the same spot is simpler than moving one, because it reuses the existing flange and supply valve, but it is still plumbing work in Texas. Replacing a toilet generally needs no city plumbing permit; that is a separate question from who may do it. Moving a toilet, adding one, or changing the drain means new plumbing lines and usually a permit.
Both bars in place
Both bars in place. From bathtub grab bars installed, one of Daniel’s projects.

Showers, sinks and shower doors

  • Showerhead and handheld sprayer. A new showerhead or a handheld sprayer screws onto the existing shower arm, sometimes with a diverter so you can switch between the two. Like-for-like on the existing arm is far simpler than a new valve or a second outlet, but it is still fixture work, which Texas treats as plumbing. A slide bar for a handheld mounts into the wall, which on tile means drilling carefully into the right spots, the same tile work as a towel bar. A new valve, a second water outlet, or a body spray system means new plumbing lines.
  • Sink pop-up drain. The pop-up stopper and its drain body sit in the sink and connect to the trap below. Replacing a worn or leaking pop-up assembly is plumbing repair. Mention it if the trap or the drain pipe going into the wall looks corroded or is leaking, because that changes the job.
  • Supply lines under a sink. The flexible lines between the shutoff valve and the faucet or toilet are worth replacing before they fail, and replacing them on the existing valves is simpler than any change to the pipes. It is still plumbing work, so ask who will do it. If the shutoff valve itself won’t turn, drips, or the pipe it sits on is corroded, mention it, because the valve has to be dealt with first.
  • Shower door handle. Most handles bolt through holes in the glass or the frame and can be replaced with one that fits the same hole spacing. Measure the spacing, or send a photo with a tape measure across it. A cracked glass panel or a frameless door that sags on its hinges is work for a glass company.

A few things to fix in the bathroom? Tell Daniel about it

Towel bars, accessories and hardware

A towel bar on tile fails when it’s rushed. Tile needs a bit made for it, anchors suited to what is behind the tile, a stud where one is available, and a dab of sealant so water does not follow the screws into the wall. How do you install grab bars that actually hold? covers the same drilling questions for bars that must carry weight. A towel bar is not a grab bar, and should never be used as one.

Installing a full accessory set, with towel bars, rings, a paper holder and robe hooks, is mostly about layout: heights that suit the people using the room, reach from the tub or toilet, clearance for doors and drawers, and everything level and consistent.

Cabinet hardware across two bathrooms is a good small job to combine with the rest. The key measurement is the hole spacing on your existing pulls. New pulls that match it go on cleanly; a different spacing means filling old holes. A jig keeps every knob and pull at the same spot, as in Daniel’s cabinet door repair.

A loose vanity, or a damaged vanity backsplash

A vanity cabinet that moves when you lean on it was either never fastened to the wall well or has worked loose. It gets shimmed level and screwed to the studs behind it. If the base itself has broken down, it can often be repaired: in Daniel’s bathroom vanity repair, the top was lifted off, the cabinet base was repaired and squared, and everything went back together with drawers and doors working.

The short backsplash on a vanity top is usually a separate piece glued to the wall and caulked. A loose one can be cleaned and reset. A cracked or chipped one can be replaced, but a new stone piece has to be cut to match, which usually means a countertop fabricator, and stone varies from slab to slab. Either way, the joint along the top needs fresh caulk so water can’t run down behind the vanity.

A leak you can’t see: call a plumber first

A stain on the ceiling below a bathroom, a wet wall next to the tub, or water appearing with no visible source needs a licensed plumber to find and fix the leak. Shut off the water to that fixture, or at the main if you can’t stop it, and call. Once the leak is fixed and the area has dried, a handyman can repair the drywall, trim, cabinet or floor. Doing it in that order matters: a patch over an active leak only hides it.

Put the small things on one list

Several small bathroom repairs often fit in a single visit. Walk each bathroom and write down everything, from the running toilet to the cracked caulk. How do I make a handyman punch list that one visit can cover? shows how to write it so nothing gets missed.

Then send the list with photos through Request service. Mark anything you’re unsure about, and we’ll say up front which items are handyman work, which are plumbing, and how we handle the plumbing part on your job.

Frequently asked questions

Can a handyman replace a bathroom faucet?
Replacing a faucet is plumbing under Texas law, even on the existing supply valves and drain, so ask who will do it and whether they are licensed. We’ll tell you how we handle it on your job. Before you buy, check that the new faucet fits the number of holes in your sink or counter, and mention it if the valves under the sink are seized or leaking.
Is replacing a toilet handyman work in Texas?
In Texas, replacing a toilet, or the parts inside its tank, counts as plumbing, which is a licensed trade. Replacing a toilet generally doesn’t need a city plumbing permit, but that is a separate question from who may do the work. Ask who will do it and whether they are licensed; we’ll tell you how we handle it on your job.
Why does it matter whether my shutoff valves work?
Almost every fixture repair starts by closing the valve under the sink or behind the toilet. Valves that haven’t been turned in years can stick or start dripping when they are finally used. If yours won’t turn, mention it when you ask for the repair, because the valve has to be dealt with before the fixture work can happen.
Is it worth repairing an old toilet, or should I replace it?
Tank parts are inexpensive and standard, so a running or slow-filling toilet is usually worth repairing. Replacement makes more sense if the porcelain is cracked, the toilet has been reset several times and still leaks at the base, or you want a different style or height.
Daniel Myers, founder of The DFW Handyman

Ask Daniel

A few things to fix in the bathroom?

Tell Daniel what you need and he'll explain how it's handled, including any plumbing part.